10-15-2006 03:53 PM - edited 03-18-2019 06:28 PM
i don't know, but it seems i made a stupid mistake somewhere in my config.
i have this router that works fine when it's connected to my callmanager
and when i disconnect network for srst test , it goes to fallback and everything works fine but if i call the fxo port it will not transfer to my AA in my CUE
i tried with connection plar opx and AA didn't pickup the line and when i tried with connection plar i heard busy signal.
i attached config file
any help would be appreciated
Solved! Go to Solution.
10-16-2006 03:04 AM
Hi,
You could try these additional lines depending on your IOS level.
For IOS 12.3(13)T or earlier
use
!
!
config#call application alternate default
!
!
For IOS 12.3(14)T or later
use
!
!
config#application
(config-app)#global
(config-app-global)#service alternate Default
!
!
These commands hand the service to DEFAULT when MGCP is not available.
http://www.cisco.com/en/US/tech/tk1077/technologies_tech_note09186a0080144630.shtml
Hope this helps
Alex
10-16-2006 03:04 AM
Hi,
You could try these additional lines depending on your IOS level.
For IOS 12.3(13)T or earlier
use
!
!
config#call application alternate default
!
!
For IOS 12.3(14)T or later
use
!
!
config#application
(config-app)#global
(config-app-global)#service alternate Default
!
!
These commands hand the service to DEFAULT when MGCP is not available.
http://www.cisco.com/en/US/tech/tk1077/technologies_tech_note09186a0080144630.shtml
Hope this helps
Alex
10-16-2006 06:45 PM
Thanks for help
worked!!!
appreiated
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: