Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Creating new Enhanved IOS Conference Bridge in CM 4.2(3)

I have a 3825 fully loaded with PVDM2. I have created a DSP farm and a profile for transcoders and a profile for conferencing. In CM, Im trying to create a new hardware conference bridge. What MAC address do I use? I have used CFB<MAC> where <MAC> is the MAC of the Gig interface on the 3825. After resetting the new CFB in CM, I still dont see an IP address in the CM window and sh sccp on the router indicates that both my transcoders and conference bridge are not registered

Jeff

2 REPLIES

Re: Creating new Enhanved IOS Conference Bridge in CM 4.2(3)

Jeff,

The MAC address used to register with CCM will be that of the interface specified with the "sccp local" command on the 3825.

Hope this helps. If so, please rate the post.

Brandon

New Member

Re: Creating new Enhanved IOS Conference Bridge in CM 4.2(3)

Brandon -

I appreciate your response, but unfortunately, that is not it. Gig 0/0 IS the interface that I have specified in the sccp local command. I will try to post the config later

112
Views
0
Helpful
2
Replies
CreatePlease to create content