I have the standard Emergency Response (CER) setup with 3 CTI route points (911,912 and 913XXXXXXXXXX) and 6 CTI ports. I've had this config set up and working for about 2 years. The problem is that for whatever reason, my secondary rp (912) is no longer registered with CCM. All other rp's are though.
I tried deleting and recreating that route point, re-associated it to my CERADMIN user, bounced CTI manager on both sub and pub and still no registration.
My last resort is to reboot the sub and cross my fingers. Any one have any other suggestions? Thanks in advance.
IntroductionCUCM Routing RulesDial String implementation PolicyCUCM Routing LogicSIP URI Call Routing Analysis+++ Case Study: 1 ++++++ Case Study: 2 +++Conclusion
Over the last few months, I have had the privilege of working on SI...
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...