CUAE (Metreos) Configuring it to set QoS on its Packets
Hi I have a customer who has metreos or Cisco UAS/UME, version 2.3 and it appears from the packet captures that is does not mark and packets for ToS or DSCP. Is this configurable from within the Metreos at either an application, script or OS level. If not the customer will have to configure the marking on the switch but I would just like it confirming the metreos cannot be configured to do it.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...