Hi, i have installed the CUBAC over W2K3 and followed all the steps for installation and configuration. And all luck fine but when I a user logon like operator, he do not reveived no one call in the queue.
When the CTI route point is dialed, the call is forwarded to one of the DN of service device. But I do not see the call in the queue.
Additionally the internal directory do not show any match when I try to do a user search.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.