I have a CME that I am using as a centralized call manager for the CME site and 2 remote sites. The 2 remote sites have MPLS circuits, but to setup SRST the local telco services in the area are low quality and unusable. A plan was to setup SIP trunking on the CME with DID numbers for the area that doesn't have usable local services and calls to these numbers would be routed to that site so that it would appear that it was a local service. The SIP trunking would also provide outbound calling from the area with the unusable local services. For a SIP call to tranverse between the 2 locations is CUBE required on the remote routers for IP to IP calls. All phones register to the CME and calls presently are all sent to and from the CME PSTN connections with the idea of the SIP trunking just being another PSTN connection.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...