I wanted to know can you someone point me in the right direction to some documentation that will show me how to configure Qos for a Cube router. The reason I ask it becuase I have a location in NYC that everytime they try to transfer a call the call drops. The guy who's place I took opend up a case with TAC and the TAC engineer said " As previously stated on my previous email, the running-config suggests that there is no QoS service-policy applied to any interface; hence, the router is not applying any kind of priority queuing and will treat the packets on a FIFO (First In First Out) fashion. However, I would like to get a show tech-support output from the router in question for me to get a better look at the overall setup for this router as well as its interfaces". I just sent the TAC engineer the info that he requested. I don't know if TAC wil help with configuring QoS but if they don't what is the easiest way to configure QoS on the interfaces. Thanks in advance for the help and I look forward to your replies.
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: firstname.lastname@example.org Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...