We have thousands of users configured with the same BPOS UM connector, no issues. We have one account that can not access their exchange mailbox, and have been told the mailbox properties/permissions are set properly by Microsoft.
Does anyone have any suggestions as to what this error message really means? Would traces give me more information or just tell me the same level of detail?
You mention a "connector" so I am assuming this isn't Single Inbox/UM for CUC and Exchange or maybe just a mis-use of the term "connector." If you are using some odd connector solution with proxy smtp to make this work, I would imagine this isn't in our range of supported solutions. If you are using SIB, then we need to know additional information.
What version of exchange?
Are you using HTTP or HTTPS on the UM account?
Are you using Basic, forms based, or NTLM on the UM account?
From what I see on the error you posted here, it seems to be an issue with access just with that one account...
ResponseClass="Error">Access is denied. Check credentials and try again.ErrorAccessDenied0]
It even says to check credentials.
Also keep in mind that we only support hosted Exchnage of Office365 or on site Exchange with SIB CUC solutions. If it is true MS BPOS, then it would have to be approved by bu before being implimented. Please provide the additional info as to what solution this is (ms connector of some kind or SIB) and answers to the other questions posed and we might be able to help you further.
Was there any resolution to this issue? I have this same with (UCON 8.6.2 - single inbox using BPOS, NTLM, HTTPS, Exchange 2007 (latest SP) with only a few users everyone else is working without issues. I have re-applied all of the exchange impersonation permissions as outlined in the Cisco guide for the service account being used. I have applied these permissions at the organizational level to no avail. I'm about to call Microsoft on this issue. How were you able to resolve this if you did? Thanks Phillip
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...