08-14-2006 09:17 AM - edited 03-18-2019 06:15 PM
After converting to Unity Connection everything seemed fine. But now my users are reporting getting a busy signal some of the time when they hit the message button, and outside callers are sometimes getting a busy signal instead of a greeting when the call goes to voicemail. Any suggestions on where to look for problems?
08-14-2006 12:40 PM
Hi -
Look at your Unity Connection integration with your phone system. If CallManager, are all of your ports registered? On Unity, how many of the ports are capable of answering calls? Your symptom sounds like all ports are in use. Look at Telephony Integrations in Cisco Unity Connection Administration. You can add and edit integrations there, as well as set port capabilities. A general rule of thumb is 75% of your ports should be configured to answer calls. Under Reports, I would run the Port Usage Report, which will tell you the number of ports in use by hour/day.
Ginger
08-14-2006 03:30 PM
30 ports are set to answer calls, 2 are for MWI, all of the ports are registered.
08-15-2006 06:49 PM
It turned out to be a problem with the hunt group configuration in callmgr. Thanks for your help.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: