CUCI-Lync 9.2 with CUCM 8.6 - Cisco Unity Connection Visual Voicemail Not Working
I have CUCM and CUC 8.6.2 running and MOC with CUCI-Lync 8.5 (with visual Voicemail) running OK with full registry configuration (see below). We are moving to Lync 2013 and want to use CUCI-Lync 9.2.
A basic install of CUCI-Lync 9.2 works fine with CUCM (with manual setup of TFTP, CCMIP and CTI) but not with CUC. I can only call the VM Pilot but I don't get my visual voicemail. In the CUCI-Lync parameters I type in my CUC server IP adress and credentials but get a message saying that it can't connect.
As the config guide describes a config with CUCM 9 (with UC services) which I don't have in V8.6. I've tried using the old registry configuration or no registry configuration at all, I can't get CUCI-Lync to connect to CUC...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...