we have UCM 7.1(2), CuciMoc 7.1.3 and OCS R2. After some effort, we are able to get these clients to work on Windows 7, 64bit. Yes, I do understand that Cisco does not officially support Windows 7, 32 or 64 bit yet, but I am not sure this is an client OS issue.
when placing internal calls, caller ID is working both ways. However, if an external call comes in, and the client does not already have that number in the contact list in OCS, we get an "unknown number". when calling the deskphone, caller id shows up properly.
I didnt setup the OCS server, or install the CSF, setup dialing rules, etc, so I am kind of flying blind.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...