CUCM 10.5 and Exchange 2013 Integration for Unified Messaging
Is there a document that is relevant to the integration of CUCM 10.5 and Exchange 2013? I recently did an upgrade to from 8.5 to 10.5 and while the pre-existing configuration for a 2010 Exchange server is working, the newly setup connection to 2013 errors out(rang but then asked for a mailbox rather than being able to leave a message).
I'll be connecting to the machine later to see if I can pull any information using RTMT, but wanted to see if there may be a guide that I can review and verify all the settings are correct on the CUCM side prior to checking the Exchange server. I had found something for 9.1, but the options are a little different in 10.5.
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: email@example.com Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...