Re: CUCM 7.X - CLI presentation when Single Number Reach is ena
I dont think so. I have tried with it and cant change it. So when the call goes out to the cell phone, the caller ID is the calling number. I know telepacific carrier does not accept this on their broadcom softswitch. It has to be a DID on their trunk or gets rejected. Drives us nuts because we cant change the number or we could, but then other items would not work. (caller ID from the IP phone) We could mask all numbers, but ....
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...