02-11-2014 01:21 PM - edited 03-19-2019 07:52 AM
Off-net calls come in with a double-ring, where internal calls have a single ring. Customer would like to stop this from happening.
is there a way to modify this cadence for off-net calls other than classifying all gateway / trunk calls as "off-net?"
Thanks
Matt
Solved! Go to Solution.
02-11-2014 09:39 PM
Hi Matthew.
You can change Call Classification value under Service Parameters --> Cisco Callmanager "Device General" Section default is off-net.
HTH
Regards
Carlo
Please rate all helpful posts
"The more you help the more you learn"
02-11-2014 09:39 PM
Hi Matthew.
You can change Call Classification value under Service Parameters --> Cisco Callmanager "Device General" Section default is off-net.
HTH
Regards
Carlo
Please rate all helpful posts
"The more you help the more you learn"
02-12-2014 08:25 AM
Carlo,
Thanks for the reply.
I was trying to figure out if there was a way to modify the cadence without marking every call "on-net." Is there any detrement to having all calls marked on-net?
Thanks
Matt
02-12-2014 12:52 PM
Hi Matthew.
The only onption offered by CUCM is changing call classification to have the same ring cadence for all calls.
I don't see any particular issue on changing that value.
HTH
Regards
Carlo
Sent from Cisco Technical Support iPhone App
02-14-2014 09:59 AM
thank you for clearing this up.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: