Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

cucm 9.1 off-net ring cadence

Off-net calls come in with a double-ring, where internal calls have a single ring.  Customer would like to stop this from happening.

is there a way to modify this cadence for off-net calls other than classifying all gateway / trunk calls as "off-net?"      

Thanks

Matt

Everyone's tags (1)
1 ACCEPTED SOLUTION

Accepted Solutions

cucm 9.1 off-net ring cadence

Hi Matthew.

You can change Call Classification value under Service Parameters --> Cisco Callmanager "Device General" Section default is off-net.

HTH

Regards

Carlo

Please rate all helpful posts

"The more you help the more you learn"

Please rate all helpful posts "The more you help the more you learn"
4 REPLIES

cucm 9.1 off-net ring cadence

Hi Matthew.

You can change Call Classification value under Service Parameters --> Cisco Callmanager "Device General" Section default is off-net.

HTH

Regards

Carlo

Please rate all helpful posts

"The more you help the more you learn"

Please rate all helpful posts "The more you help the more you learn"
New Member

cucm 9.1 off-net ring cadence

Carlo,

Thanks for the reply.

I was trying to figure out if there was a way to modify the cadence without marking every call "on-net."  Is there any detrement to having all calls marked on-net?

Thanks

Matt

Re: cucm 9.1 off-net ring cadence

Hi Matthew.
The only onption offered by CUCM is changing call classification to have the same ring cadence for all calls.
I don't see any particular issue on changing that value.

HTH

Regards

Carlo

Sent from Cisco Technical Support iPhone App

Please rate all helpful posts "The more you help the more you learn"
New Member

cucm 9.1 off-net ring cadence

thank you for clearing this up.

843
Views
5
Helpful
4
Replies
CreatePlease to create content