CUCM-BE / UC - Remove mailbox with user still in AD
Here is my delima, we are running CUCM-BE 7.0 with LDAP integrated. I have two users that both have mailboxes. However, user A (ext. 7980) was moved to a position where she will not have a phone but will still be using a computer and therefor need an AD account. User B who had ext. 2866 is going to be moving to take over user A's old job. She will inherit extention 7980 and 2866 will not be used for the time being. I went ahead and in CM associated user B with the device and set her primary extention as 7980. I removed device association with user A and have none as her pri extention. On the CM side all is well, however on Unity it will not sync. I am sure this is because user A still exists and because they dont have a primary extention it basically says no. All I really want to do is just remove the mailbox from user A (however cant do this because it is synced with CM which in turn is synced with AD) and then sync user B and it should inherit the new extention (I think). Does anyone know how I can execute this correctly.
Re: CUCM-BE / UC - Remove mailbox with user still in AD
So the only way I have found to do this and I have complained to Cisco already about this, is to move the AD user to a different OU that is NOT synced with CUCM or CUC. Once they are moved, resync CUCM, and then in Connection, you delete the subscriber.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.