01-01-2010 02:40 AM - edited 03-19-2019 12:13 AM
Hello, im getting ready to take the CIPT I exam and i installed a CUCM 6.0 on a virtual machine, but i have no clue hot to get to the GUI from the CLI,
I can ping my virtula machine from the host, but i cant access throug the brownser either.
And the book that im following " Implementing Cisco Unified Communications Manager Part 1 CIPT1 Authorized Self Study Guide" doesnt say anything about it.
Can anybody help me ?
Thanks in advance.
Cesar
01-01-2010 01:12 PM
Make sure Tomcat is running, try restarting the service.
Open a web browser and type:
HTH
java
If this helps, please rate
www.cisco.com/go/pdihelpdesk
01-01-2010 11:13 PM
That wasnt the problem but it put me on the correct direction, all the services are stoped so im doing a new installation, i was using 30 gb of hard disk i readed that i need 74 is that right?.
Id like to rate, but i cant see how with that link.
thanks
Cesar
01-02-2010 01:37 AM
Its ok now, i had the proxy enabled all this time, but thanks anyway
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: