Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

CUCM613 UnityConnection2.1.2 import users

CUCM 6.1.3.1000-16 + UnityConnection 2.1.2.1000-380.

End users are created on CUCM (no AD sync) then when users are imported on UnityConnection,

I have no more access to the end-users parameters on CUCM admin. I get a white page.

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: CUCM613 UnityConnection2.1.2 import users

Guy,

Speaking from a UC perspective... I have seen this in the past. Check out http://tools.cisco.com/Support/BugToolKit/search/getBugDetails.do?method=fetchBugDetails&bugId=CSCso43615

The workaround is to append .localdomain to the UC Application Server on the CUCM side. This works if you have only 1 UC Application Server. If you have multiple UC servers, you will only be able to add one instance of .localdomain. In that case, you'd need to upgrade. An upgrade to CUCM 7.0 did the trick in the past.

Hope that helps,

Brad

3 REPLIES
Cisco Employee

Re: CUCM613 UnityConnection2.1.2 import users

Guy,

Speaking from a UC perspective... I have seen this in the past. Check out http://tools.cisco.com/Support/BugToolKit/search/getBugDetails.do?method=fetchBugDetails&bugId=CSCso43615

The workaround is to append .localdomain to the UC Application Server on the CUCM side. This works if you have only 1 UC Application Server. If you have multiple UC servers, you will only be able to add one instance of .localdomain. In that case, you'd need to upgrade. An upgrade to CUCM 7.0 did the trick in the past.

Hope that helps,

Brad

Community Member

Re: CUCM613 UnityConnection2.1.2 import users

Hi Brad,

Thank you so much for your answer.

Kind Regards

Guy

Cisco Employee

Re: CUCM613 UnityConnection2.1.2 import users

Sure, no problem. :)

122
Views
0
Helpful
3
Replies
CreatePlease to create content