Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

CUCMBE 7.1(3)

Hello I just installed a CUCMBE version 7.1(3) uploaded the proper licensing and I have the basic config on the application, however when i try to place an internal call as soon as i press "Dial" all the phones unregisters no matter what. I can't dial

have you seen this issue before ?

please assist

thank you

1 REPLY
Red

Re: CUCMBE 7.1(3)

I have not seen this problem before.  But if this problem is reproducible, it's very easy to troubleshoot.

We need detailed "Cisco CallManager" traces and a packet capture from the phone.

If the phone "reset by itself", there could be two reasons (besides hardware problem):

1) CUCM sent it a "reset" instruction

or

2) It lost keepalives from CUCM.

Michael

http://htluo.blogspot.com

211
Views
0
Helpful
1
Replies