I have a friend who just picked up a contract to install CUCME and he asked me to help him out. I'm familiar with CUCM but not CUCME, I've never worked on it before but I wanted to know if it pretty straight forward to install and configure. If so is there any sites that anyone can recommend that I can read up on and any kind of literature that I can read that will help me out.All he gave me was what the hardware was and he told me it was Cisco C2901-VSEC-CUBE/K9 and that they want 5 phones installed. Any help would be greatly appreciate and thanks in advance.
I wanted to know would you know off hand how long does an install of CUCME take. Because they told me that they want me to be onsite at 1:30 to be there for 2 when the telcom provider does the PRI. And this office closes at 5.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...