running cue 3.1. integration with CM. Attempting to figure out how to access vm externally. I set up a cti route point forward all to vm and I get a message saying that number does not match any mailbox goodbye. Can't hit # or anything.
You don't want to set up a number to forward all. If a call is presented to CUE with forwarding information, it assumes that it's supposed to route the call to a mailbox. If the pilot number is not a DID number, then you need to set up a translation pattern that translates the DID number you want to use to the CUE voicemail pilot number.
If this is a custom AA script, then you could use the Call Subflow (voicebrowser.aef) step instead of a Call Redirect step (pointing to the voicemail pilot number). The only problem is that if you have a call that is forwarded to the AA. You still should use a translation pattern to get to the AA pilot number, not a RP with call forward all.
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: firstname.lastname@example.org Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...