I had configured a script on CUEeditor (to work with AA) that when there is an incoming-call it provide a audio prompt, after the audio prompt the script make a call redirect to an extension, and all works good. The problem appear when the extension is busy. I had configured the script that when the extension is busy it must provide another audio prompt, but this second part not work!!! all audio files are uploaded in flash correctly, and when i validate the script all seems to be ok. what can be the problem?
Re: CUE-Editor Ver2.2.2 and Script not working good.
Is the CUE integrated with CME or CCM? Assuming it is CME, then you're probably using the BYE/Also SIP transfer method. If you change that to something else it'll work (under 'ccn subsystem sip' on CUE). This will only be available in CUE 2.3.1 or later.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...