Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

CUE stuck at "Waiting for IOS to register IP address"

I am running a UC520 with the CME 7.0 code. Currently I am stuck with CME waiting for IOS to register its IP address. I have tried changing boot options but am confused why it will not allow me to get past this point. I can ping out of the devices to the network so to my knowledge my network connections are not the problem.

Any ideas?

4 REPLIES
Hall of Fame Super Gold

CUE stuck at "Waiting for IOS to register IP address"

That happens whe router is not coinfigured correctly, under service-module and host route to module.

Blue

CUE stuck at "Waiting for IOS to register IP address"

Hi,

Was it working before?

Give following command

Service-module integrated-service-engine 0/0 shut

and then restart the router.

Regards

Ronak Patel

Please rate helpful posts.

Regards Ronak Patel Rate all helpful post by clicking stars below the answer.
Cisco Employee

CUE stuck at "Waiting for IOS to register IP address"

The IP address of the service module is assigned in the CME configuration.  During bootup, the module uses the SCP protocol to obtain the IP address from the CME router.  So take a look to see if you have a "service-module ip address a.b.c.d ..." assigned and the interface is not shut down.  Otherwise, do a "show run interface service-module x/y" on the CME and post it.

New Member

CUE stuck at "Waiting for IOS to register IP address"

were anyone for you guys able to solve this . having the same issue with a uc650

1754
Views
0
Helpful
4
Replies
CreatePlease login to create content