You're likely going to have issues going to a platform with less disk space and less available mailboxes. It won't let you create all the users, that's for sure.
Also, the size of each mailbox is defined on a per user basis, and you may exceed the total disk space with even just 60 users from the CUE-EC module. So you may need to tweak the configuration to lower the mailbox sizes such that the total count is less than the total disk space of the CUE moduel.
You should test this out in your lab and see how the restore goes. Worst case scenario, delete enough users to only have 60 users on the old system, change the mailbox sizes in the config, and then take a backup like that to restore on the new device.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...