Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

CUOM ExceededMaximumUptime on DevType: Voice GW

Hi

Operation Manager keep reporting for one of my H.323 GW's, that it has ExceededMaximumUptime on IF-X.X.X.X 10/75 [Vi1]

I cant see what is eventually wrong, and are not able to dig in any further on this. It is not possible to disable polling on this int. Are not sure what interface is causing this, the other GW is ok, and they have same conf.

1 REPLY
Silver

Re: CUOM ExceededMaximumUptime on DevType: Voice GW

The ExceededMaximumUptime event or notification is generated if a backup interface stays up too long. The default is 0 seconds.

When you set the value of Maximum Uptime parameter on Backup or dial on demand Interface to 0, the ExceededMaximumUptime event gets disabled.

148
Views
0
Helpful
1
Replies
CreatePlease to create content