Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

CUPC and BAT

My setup is CCM 6.1 with CUPS 6.0. The users will be using extension mobility and CUPC for presence. My understanding is that each user is going to need a UPCxxxx phone device as well as their UDP. If I create my UPC devices using BAT I can't see any way of populating Primary Phone field so each UPC uses 3 DL's rather than 1 in adjunct mode. Also I can't see anyway of populating the 'Users associated with Line' field on the line config page of the UPC or the UDP.

The only way I can see of doing these currently are by configuring individually which is very nasty. Has anyone deployed CUPC and managed to get around these issues ?

Any help appreciated.

1 REPLY
Super Bronze

Re: CUPC and BAT

Hi

You don't need the UPCxxx devices unless you are using SIP softphone mode. If you just want presence and deskphone control you can miss them out.

Regards

Aaron

Aaron Please remember to rate helpful posts to identify useful responses, and mark 'Answered' if appropriate!
159
Views
0
Helpful
1
Replies
CreatePlease to create content