I'm facing a weird problem here, we have CUPS 8.5 integrated with CUCM 7.1 in our environment and it works swimmingly before.
But today, when i tried do the routine adding a new user procedure:
1. Capabilities Assignment
2. Create new UPC profile with DN assigned.
3. Associate device in End User Mgmt and select the primary extension.
Then, to my surprise the user unable to login (wrong username & password error appear). I've check LDAP directory whether the user was in the correct OU and stuff only to found everything was in correct order. So, i tried troubleshooting.
1. using my ID as testing, i un-associate all device under my End User Mgmt section.
2. Re-associate it to different CUPC profile.
3. Change primary extension to the new CUPC profile DN.
Guess what, i'm able to login but the CUPC hold my old extension. The CUPC that in the registered to CUCM is my original CUPC (which i'm already dis-associate just now) instead of the CUPC profile i did in step 2 above.
So, I jump into conclusion that my CUPC did not sync with changes made in the CUCM thus it still hold the old configuration. My question is, how do rectify this kind of issue?
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...