Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

CUPC softphone mode and CCM Group

Hi all,

I have noticed that when configuring CUPC under CUP 8.5 you have to define an active and a maximum two backup TFTP servers in the settings page for CUPC (Application>Cisco Unified Personal Communicatore>Settings). In other word you have to define the CCM group that will be used by all CUPC clients. Does it mean that all the CSF device that I have to configure under CUCM must have a device pool with this very same CCM group?

Best Regards,

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

CUPC softphone mode and CCM Group

No, you're confusing things.

The TFTP is where the phones get their config file, that's it.

The config file they get from the TFTP is what contains the CUCM group config, it can be the same server(s) or other servers from your cluster depending on your config/deployment.

HTH

java

If this helps, please rate

www.cisco.com/go/pdihelpdesk

HTH

java

if this helps, please rate

www.cisco.com/go/pdi
1 REPLY
Cisco Employee

CUPC softphone mode and CCM Group

No, you're confusing things.

The TFTP is where the phones get their config file, that's it.

The config file they get from the TFTP is what contains the CUCM group config, it can be the same server(s) or other servers from your cluster depending on your config/deployment.

HTH

java

If this helps, please rate

www.cisco.com/go/pdihelpdesk

HTH

java

if this helps, please rate

www.cisco.com/go/pdi
353
Views
0
Helpful
1
Replies