Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Community will be in read-only mode on 12/14/2017 from 12:00 am pacific to 11:30 am.

During this time you will only be able to see content. Other interactions such as posting, replying to questions, or marking content as helpful will be disabled for few hours.

We apologize for the inconvenience while we perform important updates to the Community.

New Member

detection of a raid disk failure

what the way to detect a failure on a physical drive belonging to an array ?

3 REPLIES

Re: detection of a raid disk failure

Hi -

The failed drive will have a red X on it. If you have an HP server running HP System Tools, you can check the HP Array Configuration Utility. In the configuration view, you will see the failed logical drive as well. Also on the System management main page, you will see System status, which will also show a failed drive.

Ginger

New Member

Re: detection of a raid disk failure

Thanks for your answer.

Now, is there a way to get this information automatically when it happens : by mail or SNMP OID change status ?

I don't want to connect every day to CUCM to check the HD status.

best regards

New Member

Re: detection of a raid disk failure

I am looking for a soltion for this also.Can

it be done through RTMT?

Thanks!

197
Views
0
Helpful
3
Replies
CreatePlease to create content