Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Dial plans and peers in CUCM 7

dear any body

can you please tell me that how i can configure dial peers that i should call from one voip to another voip system in CUCM7 becouse in CME in routers the configuration was simple so can any body tell me how i can do this in call manager 7 please its need for me to learn this asap and to implement this in my office.

the CME configs was like this

dial-peer voice 1 pots
 destination-pattern 555....
 port 1/0:1

dial-peer voice 2 voip
 destination-pattern 555....
 session target ipv4:192.168.1.1

but i dont know in cisco call manager 7 can any body help me pleaseeeeeee


with regards

http://www.ciscosystems.com/en/US/i/000001-100000/35001-40000/36501-37000/36849.jpg

Waisudin Farzam IT/DataCenter Specialist P E: wfarzam@gmail.com S E: wais.farzam@gmail.com S: wais.farzam Certified Cisco ID: CSCO11404095 CCNA, CCNP, CCNA Sec, and CCIE R&S v4.0 Written Certified
Everyone's tags (6)
3 REPLIES
VIP Super Bronze

Re: Dial plans and peers in CUCM 7

You will need to create a SIP or H.323 trunk to the other system. Once that is configured you can add a route pattern and select the trunk as the off-net path to take. The route pattern will need to be in a partition that is included in the CSS of the calling party.

CME and UCM are two totally different platforms. Very little of what you understand about CME holds true in UCM and vice versa.

Please remember to rate helpful responses and identify helpful or
Cisco Employee

Re: Dial plans and peers in CUCM 7

If you want to learn about it read this

Interoperability of Unified CM and Unified CM Express

http://www.cisco.com/en/US/docs/voice_ip_comm/cucm/srnd/8x/callpros.html#wp1044453

Easiest way is to config the CME as H323 GW.

HTH

java

If this helps, please rate

www.cisco.com/go/pdihelpdesk

HTH

java

if this helps, please rate

www.cisco.com/go/pdi
New Member

Re: Dial plans and peers in CUCM 7

dear Jonathan

thx for your reply but in this case do i need a Gateway or gatekeeper in between to do this task or cucm 7 can do this job

if i need can you send me a note of step by step

regards

Waisudin Farzam IT/DataCenter Specialist P E: wfarzam@gmail.com S E: wais.farzam@gmail.com S: wais.farzam Certified Cisco ID: CSCO11404095 CCNA, CCNP, CCNA Sec, and CCIE R&S v4.0 Written Certified
860
Views
0
Helpful
3
Replies