Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

dial rules in Unified CallConnector

I have CallConnector Server for Windows setup, and I defined dialing rules. It's increated with CME 4.2.

I set my CallConnector Client to login to the CallConnector Server, but it doesn't seem to pay any attention to the server side dialing rules. It's looking only at the dialing rules defined in windows. I had to re-create all my dialing rules in windows for outbound calls to route properly from CallConnector Client to the CME and match dial-plan's.

This isn't normal behavior is it? I assumed the server side rules would take effect.

1 REPLY
Silver

Re: dial rules in Unified CallConnector

Setup CME dial-peer to match and strip out the non-extension digits

179
Views
0
Helpful
1
Replies