Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

DID configuration help

I am using CME 4.1.I want o enable Direct inward dialing in my router.My pstn no is 024481415 and my extension is in range of 200-300.

My requirement is when somebody call to my PSTN no: with extension .the call should go to the corresponding extension without going to reception.

under telephony-service i have configured below command

dialplan-pattern 1 0244814152.. extension-length 3 extension-pattern 2..

it is not working after giving the above command

i think some extra configuration is needed.I am entirely new to voip.Please help me out to solve my problem.

1 REPLY

Re: DID configuration help

Hi friend,

Please check this links, may be helpful.

Dial-Plan Patterns, DID Trunk Lines and SCCP Configuring Dial-Plan Patterns:

http://www.cisco.com/en/US/docs/voice_ip_comm/cucme/admin/configuration/guide/cmedialp.html#wp1056041

Matching the Correct Inbound POTS Dial Peer for DID:

http://www.cisco.com/en/US/tech/tk652/tk653/technologies_tech_note09186a00801142f8.shtml#did_cfg

Regards,

- adrián.

102
Views
5
Helpful
1
Replies