Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Direct Transfer To Voicemail (Unity)

Unity 4.0.5

Call Manager 4.1.3 sr1

Cisco Unity-TSP 8.0.2

Hi, I'm trying to implement the following feature (direct transfer to VM) using this older document.

http://www.cisco.com/warp/customer/788/AVVID/transfer_voicemail.html

When I set this up at the customer site, when I dial *EXT, I get "please enter your password" instead of the persons voicemail.

This works fine for us inhouse on Unity 4.0.5, tsp 8.02, but our ccm version is still at 3.3.

Does anyone know how I can get this working on the configuration listed above?

John

4 REPLIES

Re: Direct Transfer To Voicemail (Unity)

Hi John -

You may want to reference this updated document - http://www.cisco.com/en/US/customer/products/sw/voicesw/ps2237/products_tech_note09186a008015b963.shtml

Option 1 works for us. We don't have anything coded in CallManager, also on Unity 4.0(5).

Regards, Ginger

New Member

Re: Direct Transfer To Voicemail (Unity)

This doesn't address the way I'm trying to implement this. Any other suggestions?

Hall of Fame Super Silver

Re: Direct Transfer To Voicemail (Unity)

What do you see on the Unity call viewer?

Make sure that you do not forward the *, so if your directory numbers are 4 digit, in the voicemail profile mask enter XXXX, not XXXXX. I have it working on CCM 3.3 fine.

Remember to rate all helpful posts!

Chris

New Member

Re: Direct Transfer To Voicemail (Unity)

Chris,

Good point. Unity sees the call as a Direct call from the phone you are dialing from. In house on our 3.3, unity sees the call as a forward. That's clearly why I am getting "please enter your password." Should I just open a case with TAC?

John

218
Views
0
Helpful
4
Replies
CreatePlease to create content