Does anyone know how to display a name on the IP phones for incoming calls base on the calling CLI in CUCM? I know there are several applications around but our customer only needs to display one particular incoming CLI number as a name. There is a TCL script but as this is not supportable they are not keen to use this option. Ideally, we are looking at configuring something in CUCM rather than the gateway as they have a large number of gateways. Regards, Keith
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...