I have what appears to be a DTMF issue. The setup is a CUBE doing SIP to the provider and SIP to CUCM 7.x (1 sub and 1 pub). When I call lets say cisco for instance and press 1, everything is fine it accepts the entry. The issue is with the service Global Connect. Global Connect can be used to send a voice message to multiple call destinations. Basically you browse to there site and give them a number and it calls you back. So we give them the number of a DID on our CUCM system. It calls the phone and then you record at the tone and press #. The # is accepted but you need to press "1" to send the message and the "1" is not being accepted. What debugs can I use to see what is going on when i hit the "1", on the CUBE? all other DTMF seems fine both in and our but this. thanks
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.