Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Community will be in read-only mode on 12/14/2017 from 12:00 am pacific to 11:30 am.

During this time you will only be able to see content. Other interactions such as posting, replying to questions, or marking content as helpful will be disabled for few hours.

We apologize for the inconvenience while we perform important updates to the Community.

New Member

EMPTY NAT ADDRESS in the Cisco SIP IP Phone-ASAP

Hii all,

I have a Cisco SIP IP Phone with configs(on the IP Phone 7940)

Settings-->SIP configuration-->Register with proxy YES

Settings-->SIP configuration-->TFTP Directory:xxx

Settings-->SIP configuration-->Voip control port 5060

Settings-->SIP configuration-->Nat Enabled YES

Settings-->SIP configuration-->Nat Address " "

My query is " I want to leave NAT Address as Empty/Blank" But when i leave NAT Address as empty it is giving me a error as " Invalid IP address"

Is there any way to leave NAT address as empty with NAT enabled in the Cisco SIP IP Phone 7940 ? If s plz let me know ASAP

Your Prompt response would be appreciated.

Thank you in advance

Brgds,

Arif.

805
Views
0
Helpful
0
Replies
CreatePlease to create content