End User Control for Forwarding Hunt Pilot Numbers
Under the Hunt Group Pilot number configuration (Call Routing > Route/Hunt > Hunt Pilot), forwarding options for call delivery in No Answer and Busy scenarios are set. In many situations, it is desirable for an administrator to control where a call is delivered in forwaded scenarios - for example, to voicemail, or to an overflow destination. In some situations, however, users may require or request control over how calls are overflowed. Say a small hunt group of 3 users needs to forward calls to a mobile device during a team meeting.
I'm aware you can set this up using a CTI port or Route Point set with the Call-Forward all option.
To provide users with the ability to update overflow destination, the end-user must:
Approved for and granted access to the CCM User self-service web page (under End User configuration)
Have the CTI port/route point configured as an associated device (under End User configuration).
We have currently setup a udp forwarded onto a hunt pilot with a translation route added to forward onto voicemail. This works. The only problem is when voicemail is recieved via viewmail it doesn't display the orginating source number. the number displayed is the calling number on the route. Does anybody know how to get round this?
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.