Error message of MAC flapping for CCM-UC installed in UCS server
Did you configure the UCS servers or the LAN switch that the UCS servers are connected to, as an ethercannel (load balancing)? If you didn't configure the UCS servers with MIC teaming (load balancing), verify with the network administrator, that the switchports connected to the UCS servers, are not setup as an etherchannel. If the ports are setup as an etherchannel, then you will need to make the changes to the VMWare network vSwitch as seen below:
I'm not able to access my old voice mail messages all of a sudden. The recording says something like 'the message is currently not available'. This has never happened before in all the years I have been using this system. I have t...
If you have 2 ISR routers, one acting as Failover, do we need to have both the same number of SRST licenses on the 2 routers?
No. You will only need the SRST licenses on the primary router. Because this feature...