Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Errors in Controller interface ( SLIPs and Errors ).

Hi ,

We are facing the below given errors at the controller .

It has been configured as PRI EURO ( MGCP ) .

We have done the reset for the same . But still we are facing as errors are keep on increasing .

***************************************

# sh controllers e1

E1 0/0/0 is up.

Applique type is Channelized E1 - balanced

Cablelength is Unknown

No alarms detected.

alarm-trigger is not set

Version info Firmware: 20071011, FPGA: 13, spm_count = 0

Framing is NO-CRC4, Line Code is HDB3, Clock Source is Line.

CRC Threshold is 320. Reported from firmware is 320.

Data in current interval (542 seconds elapsed):

0 Line Code Violations, 0 Path Code Violations

34 Slip Secs, 0 Fr Loss Secs, 0 Line Err Secs, 0 Degraded Mins

34 Errored Secs, 0 Bursty Err Secs, 0 Severely Err Secs, 0 Unavail Secs

Total Data (last 16 15 minute intervals):

1 Line Code Violations, 0 Path Code Violations,

893 Slip Secs, 1 Fr Loss Secs, 1 Line Err Secs, 0 Degraded Mins,

893 Errored Secs, 0 Bursty Err Secs, 1 Severely Err Secs, 371 Unavail Secs

*******************************************

Can any one helpout from this issue ?

Regards ,

sinjish.K

1 REPLY

Re: Errors in Controller interface ( SLIPs and Errors ).

Please try this command:

network-clock-select 1 e1 0/0/0

Then:

Router#clear counters

There's a good chance you're missing this command.

hth,

nick

218
Views
0
Helpful
1
Replies