I have used the "Maximum Hunt Timer" option to attempt to extend the ring time for a set of phones in a broadcast hunt pilot. However irrespective of the time I set it will not ring the phones more than about 3 times. In addition the field does not allow me to set the value to more than 3 digits. The documentation states that the valid range foes from 1 to 3600 seconds. Is there some other parameter that I need to modify to allow the phones to ring longer than they currently are? In addition is it necessary to provide an outside dial tone (thats the default option)?
CM BE 6.1
HP used to ring several phones at a branch location.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...