Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Failed to setup cbarge

Hi,

I'm using cme 7.0.3, and have setup cbarge. However when the remote in use softkeys appear, and I hit "cbarge", I receive a "failed to setup cbarge" messages. Anyone have any ideas?

Thank you.

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Red

Re: Failed to setup cbarge

Hi Ryan,

Just a couple of questions here :) For SCCP phones cBarge is only supported on Octo-Line DN's, are you using Octo-lines? Second question, are you using a hardware Conference bridge?

Barge (Conference Barge)

The Barge feature enables phone users to join a call on a shared octo-line directory number by pressing the Cbarge soft key and converting the call to an ad hoc conference. This feature uses a hardware conference bridge configured in Cisco Unified CME. When the initiator barges into a call, an ad hoc conference is created between the barge initiator, the target party, and the other party connected in the call. Parties see the call information on their phone displays and, if the conference join tone is configured, hear a tone.

http://www.cisco.com/en/US/docs/voice_ip_comm/cucme/admin/configuration/guide/cmebarge.html

Cheers!

Rob

1 REPLY
Hall of Fame Super Red

Re: Failed to setup cbarge

Hi Ryan,

Just a couple of questions here :) For SCCP phones cBarge is only supported on Octo-Line DN's, are you using Octo-lines? Second question, are you using a hardware Conference bridge?

Barge (Conference Barge)

The Barge feature enables phone users to join a call on a shared octo-line directory number by pressing the Cbarge soft key and converting the call to an ad hoc conference. This feature uses a hardware conference bridge configured in Cisco Unified CME. When the initiator barges into a call, an ad hoc conference is created between the barge initiator, the target party, and the other party connected in the call. Parties see the call information on their phone displays and, if the conference join tone is configured, hear a tone.

http://www.cisco.com/en/US/docs/voice_ip_comm/cucme/admin/configuration/guide/cmebarge.html

Cheers!

Rob

1153
Views
0
Helpful
1
Replies