Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

Bronze

Failover Quest

After installing Unity on Prim and 2nd, I ran DBWalker. It gave 2 errors:

1233:(error) the ext number for this ojb conflist with one or more object in the directory. All obj found to be using ex #9991

Distr List with display name=All Subs - Unity1

Distr List with display name=All Subs - Unity2

I have not run failover wizard yet so wondering if this is ok or not?

Thanks

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: Failover Quest

That's OK - public distribution lists are "shared" across Unity installs in the same directory - generally assigning extension numbers to them should be done with caution for this reason. It's ok as a rule since you can't dial a public dl directly, you can only address it by Id or name and the lookup sequence will find the local one first before going and looking for the global one(s) that may be out there. But dbWalker will bark about the potential conflict anyway...

1 REPLY
Cisco Employee

Re: Failover Quest

That's OK - public distribution lists are "shared" across Unity installs in the same directory - generally assigning extension numbers to them should be done with caution for this reason. It's ok as a rule since you can't dial a public dl directly, you can only address it by Id or name and the lookup sequence will find the local one first before going and looking for the global one(s) that may be out there. But dbWalker will bark about the potential conflict anyway...

102
Views
0
Helpful
1
Replies