Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Fax not working

Hi,

I have 2 rightfax connected to my CUCM via sip trunk. We had a power outage and after that we are unable to send and receive fax. On the debug isdn q931 am getting the follwong error message.

Jan 14 20:09:33.597: ISDN Se1/0:15 Q931: TX -> SETUP pd = 8  callref = 0x041E

Sending Complete

Bearer Capability i = 0x8090A3

Standard = CCITT

Transfer Capability = Speech 

Transfer Mode = Circuit

Transfer Rate = 64 kbit/s

Channel ID i = 0xA9839F

Exclusive, Channel 31

Called Party Number i = 0x80, 'XXXXXXXX'

Plan:Unknown, Type:Unknown

*Jan 14 20:09:33.685: ISDN Se1/0:15 Q931: RX <- CALL_PROC pd = 8  callref = 0x841E

Channel ID i = 0xA9839F

Exclusive, Channel 31

*Jan 14 20:09:33.985: ISDN Se1/0:15 Q931: RX <- ALERTING pd = 8  callref = 0x841E

Progress Ind i = 0x8282 - Destination address is non-ISDN 

Progress Ind i = 0x8288 - In-band info or appropriate now available

*Jan 14 20:09:36.445: ISDN Se1/0:15 Q931: RX <- CONNECT pd = 8  callref = 0x841E

Progress Ind i = 0x8282 - Destination address is non-ISDN 

Date/Time i = 0x0E010E16150D

*Jan 14 20:09:36.453: ISDN Se1/0:15 Q931: TX -> CONNECT_ACK pd = 8  callref = 0x041E

*Jan 14 20:10:18.525: ISDN Se1/0:15 Q931: RX <- ALERTING pd = 8  callref = 0x841E

Progress Ind i = 0x8288 - In-band info or appropriate now available

*Jan 14 20:10:18.529: ISDN Se1/0:15 Q931: TX -> STATUS pd = 8  callref = 0x041E

Cause i = 0x82E2 - Message not compatible with call state or not implemented

Call State i = 0x0A

*Jan 14 20:10:18.617: ISDN Se1/0:15 Q931: RX <- DISCONNECT pd = 8  callref = 0x841E

Cause i = 0x82E500000000 - Message not compatible with call state

Progress Ind i = 0x8288 - In-band info or appropriate now available

*Jan 14 20:10:18.637: ISDN Se1/0:15 Q931: TX -> RELEASE pd = 8  callref = 0x041E

*Jan 14 20:10:18.913: ISDN Se1/0:15 Q931: RX <- RELEASE_COMP pd = 8  callref = 0x841E

Please help me in solving the issue.

Thanks

Nibin

144
Views
0
Helpful
0
Replies
CreatePlease to create content