Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

FXO port configuration

Hello guys,

I'm having difficulties here on assigning different extension to different voice-port. Currently I have 4 incoming lines (PSTN) to my FXO port router (c2911). Lets  say if I wanted to assign 2 FXO ports to specific extension and the  remaining FXO ports is for others extension, how the configuration looks  like?

!

trunk group Staff_FXO

!

trunk group Operator_FXO

!

voice-port 0/1/0

trunk-group Staff_FXO

!

voice-port 0/1/1

trunk-group Staff_FXO

!

voice-port 0/1/2

trunk-group Operator_FXO

!

voice-port 0/1/3

trunk-group Operator_FXO

!

For example, I have these extension numbers : 2001,2002,2003,2004,2005,2006,2007,2008

I want to assign extension 2001,2002,2003 and 2004 to use voice-port 0/1/0 and voice-port 0/1/1 for incoming/outgoing calls while extension 2005 to 2008 using voice-port 0/1/2 and voice-port 0/1/3. How the dial-peer configuration looks like? Much appreciated if you guys can assist me on this.

Regards,

Zulfadli Zakaria

2 ACCEPTED SOLUTIONS

Accepted Solutions
Hall of Fame Super Silver

FXO port configuration

Are these simply FXO lines with one phone number for each, or are these FXS/DID DID lines?

Since you mentioed the first one there is no way to map out one line to multiple extensions unless you build a hunt list and hunt the calls through the hunt list.

The way you map FXO lines to extensions is the following:

voice-port 0/1/0

connection plar 2001.

If they are FXS/DID circuits then the telco controls which numbers arrive on which lines.

HTH,

Chris

Hall of Fame Super Silver

FXO port configuration

Zul,

Great to hear it works for you, don't forget to rate all useful posts!

Chris

3 REPLIES
Hall of Fame Super Silver

FXO port configuration

Are these simply FXO lines with one phone number for each, or are these FXS/DID DID lines?

Since you mentioed the first one there is no way to map out one line to multiple extensions unless you build a hunt list and hunt the calls through the hunt list.

The way you map FXO lines to extensions is the following:

voice-port 0/1/0

connection plar 2001.

If they are FXS/DID circuits then the telco controls which numbers arrive on which lines.

HTH,

Chris

New Member

FXO port configuration

Hi Chris,

These are FXO lines with one phone number for each. I created the hunt group and list, and it works!!! thanks a lot for the advice...cheers

Regards,

Zul

Hall of Fame Super Silver

FXO port configuration

Zul,

Great to hear it works for you, don't forget to rate all useful posts!

Chris

1164
Views
0
Helpful
3
Replies
CreatePlease to create content