FXO Remains Busy after PSTN User HangUP - Only seen with Unity
Here is the situation..
I have all calls arriving on FXO ports go to Unity for Auto Attendant Capabilities. What happens is if I start listening to the Unity Conversation and I hang up the call for some reason the FXO remain open for a long period of time. Also if I get transfer to a subscriber and I reach the subscriber VoiceMail and I hang up the call, the line also remains open for a long period of time. That doesn't happen if I'm oonnected to an IP Phone and then I hang up the call then the FXO port is available in a resonable time.
I got the following command in the FXO port of the router. I don't know if I'm missing something else on the router, CCM or even Unity..
timeouts interdigit 2
timeouts call-disconnect 2
connection plar opx (VM-Pilot)
supervisory disconnect dualtone mid-call
I'm using H323 for signalling to the gateway.
Gateway - Cisco 2611XM with 12.3(7)T IP-VOICE
NM-HD-2VE with VIC2-4FXO
CCM - v3.3(3)SR4
Unity - v4.0(3)SR1
TSP - Latest TSP Version..
Can someone point me into the right direction as this is getting very critical for my client because the lines are always busy because are not getting disconnected as fast as it should be.
Re: FXO Remains Busy after PSTN User HangUP - Only seen with Uni
I don't have that command available in the router. I tried the timeouts wait-release but without any luck. After the PSTN get to the Auto Attendant and for some reason disconnect the call, the fxo port remain open for more than 1 minute.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.