Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

FXS MGCP issue after upgrade to UCCM 7.X

We have an fxs port registered with ccm via an mgcp gw (2811), we recently upgraded the Cluster from 5.1(3g) to 7.1(2b) and now the port is registered but it can't make any calls.  When you dial an extension the extension rings but then stops and you get dialtone back to the fxs port.  Is there anything that could have caused this with the upgrade?  As far as we know the fxs port worked prior to the upgrade.

Thanks,

Joe

149
Views
0
Helpful
0
Replies