Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Group Listen and BAT

I have a need to use BAT to set the "Group Listen" check box on 7911s and can't seem to figure it out. It shows up in the templates but I need to update that field on phones already in the system. Any ideas?

1 REPLY
Cisco Employee

Re: Group Listen and BAT

You probably want to ask this over on the IP telephony forum - this is for questions about the Unity/Connection voice messaging systems...

99
Views
0
Helpful
1
Replies