Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Grub Error 21 on install of cucm 6.1.2

Hello All

I am installing call manager 6.1.2 on a HP DL320 G2 3.06GHZ server. On reboot I get a Grub error 21. I am using raid 1 and I beleive I have configured the 2 * 80 gb hard disk for raid 1 properly.

Any ideas ?

Thanks

Feisal

1 REPLY
Silver

Re: Grub Error 21 on install of cucm 6.1.2

The DL320 built-in SATA RAID controller is not supported by CUCM 6.1(2). You need to have the platform install CD configure the drives during the initial install and don't modify the config at all.

The add-on HP RAID controller is not supported.

Did you change the RAID configuration on the server after installing the platform install disk? Did this ever work?

328
Views
0
Helpful
1
Replies