Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Have one message stuck in Normal Queue under Bridge 3.1.1 system admin

All:

When I open up the bridge system administration page and click on Queue status - for one of my Octel nodes, I see '1' Normal message. I have checked the bridge in/out directories, restarted the Unity bridge service, restarted digital networking to no avail. Is this a caveat in the Unity Bridge release 3.1.1 or is there anything I can check?

Any help would be greatly appreciated.

1 REPLY
Bronze

Re: Have one message stuck in Normal Queue under Bridge 3.1.1 sy

Hi,

First, I'd recommend installing the BANANA tool that's on the Bridge CD or available on http://www.CiscoUnityTools.com. BANANA parses the SFLOGs and helps present the data in the SFLOGs in a more user friendly way.

I'd also recommend working through the Bridge Troubleshooting chapter here: http://www.cisco.com/en/US/docs/voice_ip_comm/bridge/31/networking/guide/31ex/bnete09.html

Skim through the overview section to get an idea of the various logs available. And then

focus on the section "Are Outbound Calls Attempted?" here: http://www.cisco.com/en/US/docs/voice_ip_comm/bridge/31/networking/guide/31ex/bnete09.html#wp1073935

Nancy

97
Views
0
Helpful
1
Replies