CUCM 4.2 Pub and SUB at main location additional Sub deployed at remote location. Also at remote location we have another CM Cluster deployed and connected via NGC intercluster Trunk. We are trying to migrate all the remote gateways and endpoints to our Main CM cluster. When we configure 1st remote location gateway to remote Sub from Main CM cluster in-bound calls to remote site work fine, outbound calls through remote connected gateway will not work (receiving reorder) Have configured gateway as H 323 and MGCP with same results. When we switch remote gateway back to original remote CM Cluster everything works just fine. Checked CSS and works OK with other gateway in route list.
We resolved the issue, the remote gateway dial-peer's were set to strip the 9 from the dialed number, and we missed seeing that in the heat of the battle. Sorry for the needless question but maybe this will help someone else with the same issue.
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: firstname.lastname@example.org Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...